强织构铝合金残余应力检测技术研究

在铝合金轧板的残余应力研究中，由于其强烈的轧制织构，无法使用常规的X射线sin2 ψ法进行残余应力分析。以2A97铝锂合金轧制板材为研究对象，使用X射线衍射法测量材料的取向分布函数，结合Ruess、Voigt、Neerfeld-Hill模型，从理论上计算不同假设条件下材料的宏观弹性常数，得到材料表面的宏观残余应力。实验结合盲孔法进行对比验证，结果表明Neerfeld-Hill模型的残余应力分析结果与盲孔法所测结果相互吻合，建立织构材料的宏观残余应力分析方法。     

二级剪叉式液压升降机液压缸布置方式研究

分析了二级剪叉式液压升降机的三种主要布置方式,以及液压缸倾斜布置时的三种液压缸安装位置方案。对于其中的一种方案,应用虚位移原理计算求解液压缸推力,并以液压缸推力最小为目标建立优化设计数学模型,通过MATLAB软件得到液压缸推力最小时的液压缸安装位置。通过研究液压缸布置方式,提高了二级剪叉式液压升降机的设计效率和传动质量。     

Optical spectroscopic and electrochemical characterization of oxide films on a ferritic stainless steel

Colored oxide films that form on ferritic stainless steel in a high-temperature, oxidizing environment and correspond to different chemical compositions can cause a deterioration of pitting resistance and corrosion performance. Herein, optical spectroscopic and electrochemical techniques have been used to reveal the relationship between color, chemical composition, and corrosion resistance of oxide films formed in the temperature range from 400°C to 800°C for 30 min and at 800°C for 10, 20, 30, and 60 min. The substrate with a thin and dense passivation film leads to a low pitting potential but high corrosion resistance. Oxide films of yellowish or brownish color formed below 600°C are mainly iron oxides, which correspond to low corrosion resistance. No passivation characteristics can be observed for polarization curves of oxide films formed at 500°C and 600°C. The color of oxide films varies from blue to dark gray with the increase of oxidation time at 800°C. Corrosion resistance changes with different proportions of Fe₃O₄, Cr₂O₃, and FeCr₂O₄. The gray oxide films formed at 800°C for 30 min exhibit the lowest pitting susceptibility and the highest corrosion resistance.     

Corrosion Protection of Aluminum Alloys AMg3 and D16 with Chromate-Free Conversion Coatings in a Tropical Marine Climate

Protection of Metals and Physical Chemistry of Surfaces - Abstract—In this paper, chromate-free conversion coatings on aluminum alloys D16 and AMg3 are studied in a tropical marine climate....     

锂化合物对硫铝酸盐水泥性能的影响分析

硫铝酸盐水泥是近年来广受关注的重要低碳水泥品种,在快速修补和防渗堵漏应用中,需要掺入适宜的促凝剂来满足施工要求.研究了两种锂化合物对硫铝酸盐水泥凝结时间、强度的影响规律,并采用XRD和SEM手段分析水泥水化产物.结果表明,当掺入两种锂化合物之后,硫铝酸盐水泥的凝结时间有明显的降低,并且Li2 CO3对硫铝酸盐水泥的促凝作用比LiOH·H2 O更为显著;硫铝酸盐水泥的小时强度随着Li2 CO3掺量的增加而明显提高,LiOH·H2 O对水泥小时强度的影响并不明显,两种锂化合物均会降低水泥的后期强度;从水化产物的微观分析来看,硫铝酸盐水泥的水化产物种类并不会因掺加锂化合物而有所改变,Li2 CO3对硫铝酸盐水泥的1 d水化有所促进,而LiOH·H2 O不会对水化产物产生明显影响.     

基于振动实测的非均质地层钻头失效分析与对策

四川盆地作为国内页岩气开发的重点区域,通过近几年的不断攻关和实践,机械钻速得到了提高,但由于受地层复杂、可钻性差、非均质性强等地质因素的影响,导致井下钻柱系统不良振动剧烈,容易出现钻头损坏严重、钻速较低等问题,严重影响了钻井时效。为了解决上述难题,以该盆地涪陵工区上二叠统龙潭组—中二叠统茅口组为例,采用井下振动高频测量工具的实测手段,测量了钻头—钻柱系统的动态振动加速度参数,结合地层的岩性和矿物组分分析,研究钻头失效原因与对策,并开展了现场试验。研究结果表明:①在非均质地层中钻进的钻头—钻柱系统产生了大于40 m/s~2的高幅值瞬时冲击振动,高幅值的瞬时冲击是导致钻头先期失效的主要原因;②提出了抑制高幅值的瞬时冲击振动采用"减振+增压"工具组合和避免井下工具共振的钻井参数;③采用钻井新参数的试验井比邻井的高幅值瞬时振动降低了17%,单只钻头进尺增加24%,钻头工作环境得到了较大的改善,钻头使用数量减少。结论认为,该研究成果能够有效地改善钻头—钻柱系统的振动状态,有利于达成延长钻头使用寿命的目标。     

Structural,magnetic and magnetostrictive properties of Co1-xLixFe2O4 synthesized by cathode materials of spent Li-ion batteries

In this study, we investigated the effects of substituting Li⁺ for Co²⁺ at the B sites of the spinel lattice on the structural, magnetic and magnetostrictive properties of cobalt ferrites. The Li⁺ substituted cobalt ferrites, Co_1-xLi_xFe₂O₄, with x varying from 0 to 0.7 in 0.1 increments, were synthesized with a sol-gel auto-combustion method using the cathode materials of spent Li-ion batteries. X-ray diffraction analysis revealed that all the Co_1-xLi_xFe₂O₄ nanopowders had a single-phase spinel structure and the lattice parameters decreased with increasing Li⁺ content, which can be proved by slight shifts towards higher diffraction angle values of the (311) peak. Field emission scanning electron microscopy was used to observe the fractured inner surface of the sintered cylindrical rods and the increased porosity resulted in a decreased magnetostriction. The oxidation states of Co and Fe in the cobalt ferrite samples were examined by X-ray photoelectron spectroscopy. High resolution transmission electron microscopy micrographs showed that most particles were roughly spherical and with sizes of 25–35?nm. Li⁺ substitution had a strong effect on the saturation magnetization and coercivity, which were characterized with a vibrating sample magnetometer. The Curie temperature was reduced due to the decrease in magnetic cations and the weakening of the exchange interactions. The magnetostrictive properties were influenced by the incorporation of Li⁺ at the B sites of the spinel structure and correlated with the changes in porosity, magnetocrystalline anisotropy and the cation distribution.     

Comparative studies on thermal and toughness properties of polybenzoxazine composites with two functionalized graphene oxides

Abstract

Graphene oxide (GO) was functionalized by polyether amine (PEA) via two methods which were one-pot modification in acetone (GON) and two steps with the intermediate product of GOCO-Cl generated (GONS). There were more PEA successfully grafted onto GO for GONS than GON. The onset polymerization temperatures of the benzoxazine (Bz) composites decreased by the inclusion of 1?wt% of GO, GON or GONS. Thermal stability of the polybenzoxazine (PBz) composites was significantly improved indicated from the increase of weight loss temperature. T₁₀, T₂₀ and T₅₀ values of the composites with GONS were higher than that of the others. Toughness of PBzs may be enhanced by the incorporation of nanofillers, and GONS had stronger interfacial interaction with PBz matrix than GON.     

The origin of the modulated structure in Sr2CuO3+δ (δ = 0.4): [CuO2] in-plane oxygen vacancy or apical oxygen vacancy?

We propose the question of the modulated structures of copper oxide is caused by the [CuO₂] in-plane oxygen vacancy or apical oxygen vacancy. Sr₂CuO_3+δ single-crystal samples were prepared using high-temperature and high-pressure methods. The major phase of Sr₂CuO_3+δ (δ = 0.4) single-crystal system is found to be constituted by the 5 a modulated structure with the Fmmm space group, which originates from the [CuO₂] in-plane oxygen vacancy appearing in octahedral Cu-O. Besides, the presence of the [CuO₂] in-plane oxygen vacancy may obliterate the superconductivity of the system. Experimental results deduce that the oxygen vacancy may appear in the apical oxygen sites in high-temperature copper oxide superconductors.     

A dynamic SVR–ARMA model with improved fruit fly algorithm for the nonlinear fiber stretching process

Natural Computing - The fiber stretching process plays the key role in the process of fiber production and its effects is measured by the stretching ratio. The stretching ratio is determined by the...